Directions

Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings. Surface temperature should be between 50°F and 80°F. Not recommended for dense, dark colored stones.

 

1. Mask off and protect any baseboards or adjacent areas to avoid splashing and overspray onto surfaces not intended to be treated.
2. Apply an even coat of sealer with a paintbrush, paint roller or low-pressure sprayer. Do not over apply. Do not allow to puddle or dry on the surface.
3. Completely wipe up any remaining sealer using clean dry absorbent towels within 1-3 minutes of application.
4. After one hour, test for water repellency using water droplets. If water is absorbed, apply a second coat as directed in steps 2-3.
5. Do not walk on surface for at least 6 hours. Full cure is achieved in 24-72 hours.
6. Clean equipment with water.

Coverage and Expected Wear

Depending on type of stone, porosity, texture of surface and method of application –
Coverage: approximately 200-1,000 sq. ft. per gallon.
Expected Wear (with proper care): 5-10 years on exterior surfaces.

Proper Care

To maintain your stone’s natural beauty, clean surface as needed with Revitalizer™ Stone and Tile Cleaner and Protector or All Purpose Stone and Tile Cleaner.

Caution

May cause eye and skin irritation.