Directions

Always test in a small inconspicuous area to determine the ease of application and desired results. Make sure surface is clean, dry and free of loose debris. Not recommended for use on ceramic tile and dense (low absorbency) stone. Surface temperature should be between 50ºF-80ºF.

 

1. Mask off and protect any baseboards or adjacent areas to avoid splashing and overspray onto surfaces not intended to be treated.
2. Apply an even coat of sealer with a paintbrush, paint roller or low-pressure sprayer.
3. Allow the Grout Release to completely penetrate the surface for 5-15 minutes.
4. Wipe up all remaining sealer from the surface. Do not allow pooling or sealer to dry on the surface. Do not over apply.
5. Allow for a minimum of 4 hours cure time prior to grouting.
6. After grouting, remove excess grout. Do not allow grout to completely dry prior to removal.
7. Clean equipment with water.

Coverage and Expected Wear

Depending on type of stone, porosity, texture of surface and method of application –
Coverage: approximately 200-1,000 sq. ft. per gallon.

Proper Care

To prevent future staining after grouting, seal the surface with BulletProof™ or Heavy Duty Stone Sealer.

For maintenance cleaning, use Revitalizer™ Stone and Tile Cleaner and Protector or All Purpose Stone and Tile Cleaner.

Caution

May cause eye and skin irritation.