Usage Instructions
Directions

Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings.

1. Mask off and protect any baseboards or adjacent areas to avoid splashing and overspray onto surfaces not intended to be treated.
2. BulletProof™ Stone Sealer may be applied to damp surfaces one hour after standing water has been removed.
3. Liberally apply an even coat of sealer using a low-pressure chemical-resistant sprayer, roller or brush.
4. Allow sealer to penetrate the surface for 20-30 minutes. During this time, distribute excess over entire area to insure even penetration. Wipe off any remaining sealer prior to drying on the surface.
5. A second coat may be needed for porous, absorbent surfaces and should be applied 30-40 minutes after initial application as directed in steps 3-4.
6. A minimum of 30 minutes after final application, wipe entire surface with a towel dampened with sealer to remove any residue and excess sealer, if needed.
7. A full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours. Cover with red rosin paper, if foot traffic must resume before the recommended time periods have passed.
8. Clean equipment with water.

Coverage & Expected Wear

Depending on type of stone, porosity, texture of surface and method of application – Coverage: approximately 200-1,500
sq. ft. per gallon.
Expected Wear (with proper care): 3-5 years on interior surfaces and 1-3 years on exterior surfaces.

Proper Care

To maintain your stone’s natural beauty, clean surface as needed with Revitalizer™ Stone & Tile Cleaner and Protector or All Purpose Stone & Tile Cleaner.

Caution