Directions
Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings.
- Mask off and protect any baseboards or adjacent areas to avoid splashing and overspray onto surfaces not intended to be treated.
- Liberally apply an even coat of Enhancer Pro™ using a low-pressure solvent-resistant sprayer, roller or brush.
- Allow to penetrate the surface for 15-30 minutes; denser material may require more time for Enhancer Pro™ to penetrate. During this time, distribute excess over entire area to insure even penetration. Completely wipe surface dry. DO NOT ALLOW ENHANCER PRO™ TO DRY COMPLETELY ON SURFACE! Failure to remove enhancer from the surface may result in a film or residue that may need to be mechanically removed.
- A second coat may be needed for porous, absorbent surfaces or if a darker appearance is required and should be applied one hour after initial application as directed in steps 2-3.
- A full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours. Cover with red rosin paper, if foot traffic must resume before the recommended time periods have passed.
- Clean equipment with mineral spirits.
Coverage and Expected Wear
Depending on type of stone, porosity, texture of surface and method of application –
Coverage: approximately 200-1,200 sq. ft. per gallon.
Expected Wear (with proper care): 3-5 years on interior & exterior surfaces.
Proper Care
To maintain your stone’s natural beauty, clean surface as needed with Revitalizer™ Stone & Tile Cleaner and Protector or All Purpose Stone & Tile Cleaner.
Warning
Combustible. Keep container closed and store in a cool location. May cause eye and skin irritation. Do not aerosolize.
