Directions
Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings.
- Mask off and protect any baseboards or adjacent areas to avoid splashing and overspray onto surfaces not intended to be treated.
- Liberally apply an even coat of Impregnator ProT using a low-pressure solvent-resistant sprayer, roller or brush.
- Allow sealer to penetrate the surface for 15-30 minutes; denser material may require more time for sealer to penetrate. During this time, distribute excess over entire area to insure even penetration. Wipe off any remaining sealer prior to drying on the surface.
- A second coat may be needed for porous, absorbent surfaces and should be applied one hour after initial application as directed in steps 2-3.
- If sealer was not completely wiped off and a residue appears, wipe entire surface with a towel dampened with sealer. Use a white, non-abrasive nylon brush or pad to loosen residue and follow with a clean, white absorbent towel to remove.
- A full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours. Cover with red rosin paper, if foot traffic must resume before the recommended time periods have passed.
- Clean equipment with mineral spirits.
Coverage and Expected Wear
Depending on type of stone, porosity, texture of surface and method of application -
Coverage: approximately 200-1,500 sq. ft. per gallon.
Expected Wear (with proper care): 3-5 years on interior surfaces and 1-3 years on exterior surfaces.
Proper Care
To maintain your stone's natural beauty, clean surface as needed with RevitalizerT Stone & Tile Cleaner and Protector or All Purpose Stone & Tile Cleaner.
Warning
Combustible. Keep container closed and store in a cool location. May cause eye and skin irritation. Do not aerosolize.
